All systems go - we ship to the USA !
All systems go - we ship to the USA !
DRIVE UNITS BY MANUFACTURER:
Morel ST 1108 Tweeter-Black
Categories: 0.75 - 2" (19-50mm) Dome Tweeters Morel Tweeters
110mm faceplate version.
PRICED AS A MATCHED PAIR.
The Morel ST 1108 is a high-end 28mm soft dome tweeter from the Supreme range. This innovative unit features a short voice coil operating in a long magnetic gap - linear operation is maintained throughout the bandwidth even at high output levels as the coil assembly never strays from the area of peak magnetic flux (this mode of operation is often referred to as 'underhung'). The voice coil is wound with Hexatech Aluminium wire (Hexagonal section, zero air gap) and is cooled by ferrofluid. The dome assembly is hand coated with Acuflex damping compound and is field replaceable. The critically tuned and damped rear chamber yields a low resonant frequency of just 680 Hz.
Power handling is excellent at 220w nominal, 1000w peak.
As can be seen from the datasheet, the ST 1108 has an incredibly smooth response; the critical 3kHz-17kHz band is held within 2dB limits.
Available in Silver or Black, please select from the drop down menu above.
A full datasheet can be downloaded from the bottom of this page.
Resonant frequency (fs) | 680Hz | Nominal impedance (Zn) | 8 Ω |
Effective diaphragm diameter | 28mm | DC resistance (Re) | 5.2 Ω |
Ferrofluid ? Y/N | Yes | RMS power handling | 220W |
Recommended crossover | 2.5khz | Faceplate diameter | 110 mm |
Sensitivity (2.83V/1m) | 91.5 dB | Cutout hole diameter | 75 mm |
ST1108
Friendly technical support
40+ years in the trade
UK family run business
Excellent customer service
Quick dispatch
Excellent upgrade, works perfectly with the speakers it's just soldier and play, they takeaway the over intensity of the original tweeters.
I've had my Mission 734s for about 30 years and for the last five or so the bass units have been falling to pieces. I was about to take the speakers to the tip, but didn't have the heart knowing how capable these used to be. I did a little internet research and these Monacor replacements appeared to do the job. Next day delivery from Willys was impressive, as was the killer sound once the replacements were fitted (which was a simple job). I'd forgotten how these speakers make the windows rattle. Very happy customer!
Excellent service from Willys-Hifi. Caroline was very helpful and patient when answering my queries. Please be aware that some soldering is required when connecting the tweeters. Something I haven't done since I was at school over 40 years ago! They do sound good though, listening to Smoke on the Water as I write , wow 😆
thx you so much for helping me geting the twiters for my speakers i hope all good for your bisnis in the futur and that it will never close i recemed you to the norwigen hifikluben its a store in norway for parts and hifi so you brobely will get order from ther now thx agine for the parts btw you need to put a bit of fome on the back side of the speakers for it to mount in the b&w cmd1 se to make them fit i will leave som pictur of the istalsjon
I always knew that Linn should never have stopped using Hiquphon tweeters. What I don't know is why it's taken me thirty years to fit a pair in my old Kabers. It's often hard to describe sonic character ....but to pinch Linn's old line from back in the day ...they're Simply Better.(even straight out the box with soldering iron still warm)
As my Kabers are passive,I had been a little concerned that the the 8 ohm nominal impedence of the OW1 would mess with the crossover slope. I needn't have worried....if its shifted the crossover point its much for the better.
Warm thanks also to Will and Caroline for a service in keeping with the outstanding quality of the Hiquphon product.
Alan