The Satori MW16PNW-8 by SB Acoustics is a 6.5 inch 8 ohm midwoofer featuring a proprietary Papyrus / paper blended fibre cone, a high airflow cast chassis and a neodymium magnet assembly. Superb extended response with very low distortion. This unit is essentially the same as the MW16P-8 but with a natural coloured cone.
Also available in 4 ohms: MW16PNW-4.
Key Features:
- Vented aerodynamic cast aluminium chassis for optimum strength and low compression.
- Proprietary cone material with EGYPTIAN PAPYRUS™ fibres made in-house.
- Soft low damping rubber surround for optimum transient response.
- Advanced BIMAX spider for improved linearity
- Powerful optimised low distortion neodymium motor system.
- Non-conducting fibre glass voice coil former for minimum damping.
- Extended copper sleeve on pole piece for low inductance and reduced distortion.
- CCAW voice coil for reduced moving mass.
- Long life silver lead wires attached 180° apart for improved stability.
- Vented pole piece and coil former for reduced compression.
- Low piston to chassis diameter ratio.
- Gasket and bolt hole protrusions for reduced coupling to speaker cabinet.
Basic parameters:
| Resonant frequency (fs) |
29 Hz |
Nominal impedance (Zn) |
8 Ω |
| Mechanical Q factor (Qms) |
4.72
|
DC resistance (Re) |
6.2 Ω |
| Electrical Q factor (Qes) |
0.34
|
Max power handling |
60 W |
| Total Q factor (Qts) |
0.32
|
Sensitivity (2.83V/1m)
|
88dB
|
| Equivalent volume (Vas) |
49.9L |
Chassis diameter
|
165mm
|
Here's the full datasheet:
