All systems go !
All systems go !
DRIVE UNITS BY MANUFACTURER:
D2608/913000
Categories: 0.75 - 2" (19-50mm) Dome Tweeters Scanspeak Tweeters

Double magnets and fully vented motor system for minimal compression. Very low mass 26mm soft dome mounted within a die-cast alloy faceplate. This tweeter has features that would normally be found on much more expensive units and gives a lovely vibrant sound without being fatiguing. An excellent performer at this price point and one of our favourite tweeters regardless of price.
The Discovery series offer the legendary Scanspeak superior sound at a favourable cost, they combine a wealth of technical features & innovations; the sound quality to price ratio is superb.
| Resonant frequency (fs) | 700 Hz | Nominal impedance (Zn) | 8 Ω |
| Effective diaphragm diameter | 26 mm | DC resistance (Re) | 5.6 Ω |
| Ferrofluid ? Y/N | Yes | RMS power handling | 80 W |
| Recommended crossover | 2 kHz 12dB | Faceplate diameter | 104 mm |
| Sensitivity (2.83V/1m) | 91.3 dB | Cutout hole diameter | 72 mm |
Very good tweeters with a clean bright sound at a good price from a very good trusted seller
Thanks for the review Dave !
Will & Caroline
Friendly technical support
40+ years in the trade
UK family run business
Excellent customer service
Quick dispatch
Product as described, easy to cut & fit.
On reflection having now fitted the foam, I wish it was 15mm to 18mm or even 20mm thick. This is not a complaint. For a small speaker under 30cm high it’s perfect. For a larger speaker I feel a thicker sponge would hold its structure more pleasingly, its aesthetics, but important for the finished look.
I’ve been building my own home cinema as a complete DIY project and reached the stage where I needed some decent acoustic foam for my speaker panels (also DIY!) so I picked up 3 large sheets from here. They were sent quickly, packed well and moreover, are of excellent quality. With them being folded into the shipping box they were slightly creased but after leaving them out overnight on a flat surface, the creases fell out completely. They’re now in place and doing their job brilliantly. Cheers Willys Hifi!
The crossover was constructed well, I just need to figure out the best way to attach it to my Kef Concertos as they are bigger than the ones supplied by Kef that are mounted on the front of the baffle board.
Very nice deep bass look amazing with my custom made speaker
Great speedy delivery and very easy to fit. The plastic in my drivers had perished and they had suffered one too many parties! No need to make any adjustments (someone above did suggest that). I just screwed them in and the foam compressed into place. Before and after below (before I changed speaker number 2). Thank you!
