All systems go !
All systems go !
DRIVE UNITS BY MANUFACTURER:
38WE/8582T00
Categories: 10-15 inch Bass Speakers

NEW PRODUCT.
The Scanspeak 38WE/8582T00 Ellipticor is built on the same principles as its smaller siblings (18WE and 21WE), its key features are an elliptically shaped voice coil and magnet gap. Combined with a large powerful SD AirCirc magnet system the 38WE/8582T00 woofer has high sensitivity, unusually low distortion, and extremely fast transient response. This 15 inch woofer is not for the faint-hearted.
| Resonant frequency (fs) | 26 Hz | Nominal impedance (Zn) | 8 Ω |
| Mechanical Q factor (Qms) | 3.78 |
DC resistance (Re) | 6.4 Ω |
| Electrical Q factor (Qes) | 0.26 | RMS power handling | 350 W |
| Total Q factor (Qts) | 0.24 | Sensitivity (2.83V/1m) | 95 dB |
| Equivalent volume (Vas) | 423L | Chassis diameter | 380 mm |
Friendly technical support
40+ years in the trade
UK family run business
Excellent customer service
Quick dispatch
Speaker grill foam for Harbeths
I was concerned that they may not look like the original binding posts on my Rogers LS6 speakers but they are a perfect match. Quite solid. Shipping was quick and easy. I recommend the product and Willys Hifi.
Greetings from Quebec, Canada.
Product as described, easy to cut & fit.
On reflection having now fitted the foam, I wish it was 15mm to 18mm or even 20mm thick. This is not a complaint. For a small speaker under 30cm high it’s perfect. For a larger speaker I feel a thicker sponge would hold its structure more pleasingly, its aesthetics, but important for the finished look.
I’ve been building my own home cinema as a complete DIY project and reached the stage where I needed some decent acoustic foam for my speaker panels (also DIY!) so I picked up 3 large sheets from here. They were sent quickly, packed well and moreover, are of excellent quality. With them being folded into the shipping box they were slightly creased but after leaving them out overnight on a flat surface, the creases fell out completely. They’re now in place and doing their job brilliantly. Cheers Willys Hifi!
The crossover was constructed well, I just need to figure out the best way to attach it to my Kef Concertos as they are bigger than the ones supplied by Kef that are mounted on the front of the baffle board.
