All systems go !
All systems go !
DRIVE UNITS BY MANUFACTURER:
Morel ST 1108 Tweeter-Black
Categories: 0.75 - 2" (19-50mm) Dome Tweeters Morel Tweeters
110mm faceplate version.

PRICED AS A MATCHED PAIR.
The Morel ST 1108 is a high-end 28mm soft dome tweeter from the Supreme range. This innovative unit features a short voice coil operating in a long magnetic gap - linear operation is maintained throughout the bandwidth even at high output levels as the coil assembly never strays from the area of peak magnetic flux (this mode of operation is often referred to as 'underhung'). The voice coil is wound with Hexatech Aluminium wire (Hexagonal section, zero air gap) and is cooled by ferrofluid. The dome assembly is hand coated with Acuflex damping compound and is field replaceable. The critically tuned and damped rear chamber yields a low resonant frequency of just 680 Hz.
Power handling is excellent at 220w nominal, 1000w peak.
As can be seen from the datasheet, the ST 1108 has an incredibly smooth response; the critical 3kHz-17kHz band is held within 2dB limits.
Available in Silver or Black, please select from the drop down menu above.
A full datasheet can be downloaded from the bottom of this page.
| Resonant frequency (fs) | 680Hz | Nominal impedance (Zn) | 8 Ω |
| Effective diaphragm diameter | 28mm | DC resistance (Re) | 5.2 Ω |
| Ferrofluid ? Y/N | Yes | RMS power handling | 220W |
| Recommended crossover | 2.5khz | Faceplate diameter | 110 mm |
| Sensitivity (2.83V/1m) | 91.5 dB | Cutout hole diameter | 75 mm |
ST1108
Friendly technical support
40+ years in the trade
UK family run business
Excellent customer service
Quick dispatch
Product as described, easy to cut & fit.
On reflection having now fitted the foam, I wish it was 15mm to 18mm or even 20mm thick. This is not a complaint. For a small speaker under 30cm high it’s perfect. For a larger speaker I feel a thicker sponge would hold its structure more pleasingly, its aesthetics, but important for the finished look.
I’ve been building my own home cinema as a complete DIY project and reached the stage where I needed some decent acoustic foam for my speaker panels (also DIY!) so I picked up 3 large sheets from here. They were sent quickly, packed well and moreover, are of excellent quality. With them being folded into the shipping box they were slightly creased but after leaving them out overnight on a flat surface, the creases fell out completely. They’re now in place and doing their job brilliantly. Cheers Willys Hifi!
The crossover was constructed well, I just need to figure out the best way to attach it to my Kef Concertos as they are bigger than the ones supplied by Kef that are mounted on the front of the baffle board.
Very nice deep bass look amazing with my custom made speaker
Great speedy delivery and very easy to fit. The plastic in my drivers had perished and they had suffered one too many parties! No need to make any adjustments (someone above did suggest that). I just screwed them in and the foam compressed into place. Before and after below (before I changed speaker number 2). Thank you!
