All systems go !
All systems go !
DRIVE UNITS BY MANUFACTURER:
Morel TSCT 1044 tweeter
Categories: 0.75 - 2" (19-50mm) Dome Tweeters Morel Tweeters

PRICED AS A MATCHED PAIR.
The Morel TSCT 1044 is an advanced high-end 28mm silk dome tweeter from the Supreme range. Features include a Hexatech™ Aluminium voice coil, Neodymium flat pancake ring magnet, Titanium voice coil former, diecast alloy rear chamber and dual copper Faraday shorting rings (to negate rising impedance at higher frequencies). The dome assembly is hand coated with Acuflex damping compound and is field replaceable. Power handling is high at 200w. The TSCT 1044 has a very smooth, gently rising response; the critical 1.5kHz-10kHz band is held within 2.2 dB limits. A superb transducer.
Also available with 110mm faceplate : Morel TSCT 1104
A full datasheet can be downloaded from the bottom of this page.
Decoding Morel type numbers: TSCT= Titanium Supreme Coppersleeve Tweeter; 1044= 104mm faceplate, 4ohm impedance.
| Resonant frequency (fs) | 591 Hz | Nominal impedance (Zn) | 4 Ω |
| Effective diaphragm diameter | 28mm | DC resistance (Re) | 4.19 Ω |
| Ferrofluid ? Y/N | Yes | RMS power handling | 200W |
| Recommended crossover | 2.5khz | Faceplate diameter | 104 mm |
| Sensitivity (2.83V/1m) | 95 dB | Cutout hole diameter | 72.8 mm |
TSCT1044
Friendly technical support
40+ years in the trade
UK family run business
Excellent customer service
Quick dispatch
Product as described, easy to cut & fit.
On reflection having now fitted the foam, I wish it was 15mm to 18mm or even 20mm thick. This is not a complaint. For a small speaker under 30cm high it’s perfect. For a larger speaker I feel a thicker sponge would hold its structure more pleasingly, its aesthetics, but important for the finished look.
I’ve been building my own home cinema as a complete DIY project and reached the stage where I needed some decent acoustic foam for my speaker panels (also DIY!) so I picked up 3 large sheets from here. They were sent quickly, packed well and moreover, are of excellent quality. With them being folded into the shipping box they were slightly creased but after leaving them out overnight on a flat surface, the creases fell out completely. They’re now in place and doing their job brilliantly. Cheers Willys Hifi!
The crossover was constructed well, I just need to figure out the best way to attach it to my Kef Concertos as they are bigger than the ones supplied by Kef that are mounted on the front of the baffle board.
Very nice deep bass look amazing with my custom made speaker
Great speedy delivery and very easy to fit. The plastic in my drivers had perished and they had suffered one too many parties! No need to make any adjustments (someone above did suggest that). I just screwed them in and the foam compressed into place. Before and after below (before I changed speaker number 2). Thank you!
